Active Aqua 1 in Fill/Drain Fitting

The Active Aqua 1 in Fill/Drain Fitting is the fill and drain connector that links the tray to the reservoir in an ebb and flow hydroponic system. Without this part, there is no clean way for the nutrient solution to enter and exit the grow table without leaks from the bottom of the tray.

Benefits

• Threaded design with rubber gasket that seals the tray port.
• High-strength polypropylene, resistant to chemicals and fertilizer salts.
• Reusable cycle after cycle: disassemble, clean, and reinstall.
• Compatible with Active Aqua flood tables and most standard 1 in ports.
• Accepts 1 in ID hose directly from the pump line.

How to Use

Place the rubber gasket, insert the connector into the tray port, and hand-tighten the threaded nut, without overtightening. Connect the 1 in hose from the pump to the inlet of the fill connector. Rinse the part with clean water between cycles and check the gasket for wear or cracks.

Available at Pachamama with shipping throughout Costa Rica.

Technical Specifications

• Size: 1 in ID fill and drain connector for ebb and flow hydroponic trays
• Material: High-strength polypropylene — chemical-resistant and reusable
• Threaded design with rubber gasket for a watertight installation in the tray
• Compatible with Active Aqua flood tables and most standard 1 in ports
• Used as a fill inlet — connect directly to the pump hose

Instructions for Use

• Insert the connector into the tray port with the rubber gasket to achieve a watertight seal
• Hand-tighten the threaded nut — do not overtighten
• Connect a 1 in ID hose from the pump to the inlet of the fill connector
• Rinse the connector with clean water between growing cycles
• Check the gasket each cycle for wear or cracks and replace if necessary