Active Aqua 1 in Straight Connector

The Active Aqua 1 in Straight Connector is a barbed straight coupling that connects two 1-inch hose sections in the irrigation lines of your hydroponic system. It's the go-to piece when a run is too short or when you need to replace a damaged section without disassembling the entire setup.

Benefits

• Connects two 1-inch inner diameter hose sections in an inline connection.
• High-strength polypropylene, resistant to chemicals and concentrated fertilizers.
• Barbed ends firmly hold the hose for a leak-free connection.
• Compatible with Active Aqua and most standard 1-inch hydroponic fittings.
• Reusable cycle after cycle: disconnect, clean, and reassemble.

How to use

Firmly insert the 1-inch inner diameter hose over both barbs until it is well seated. Add clamps for extra security in high-flow or pressurized systems. Rinse the connector with clean water between growing cycles and inspect it at each cycle change for cracks or flow restriction.

Available at Pachamama with shipping throughout Costa Rica.

Technical Data

• Size: 1 in ID barbed straight connector — inline connection
• Material: high-strength polypropylene — chemical resistant
• Barbed ends firmly hold 1 in ID hose for a leak-free connection
• Used to connect two 1 in ID hose sections in hydroponic irrigation lines
• Compatible with Active Aqua and most standard 1 in ID hydroponic fittings

How to Use

• Firmly insert the 1 in ID hose over both barbs until it is well seated
• Add clamps for greater security in high-flow or pressurized systems
• Rinse with clean water between growing cycles to prevent salt and algae buildup
• Check for cracks or loose parts at each cycle change
• Replace any fitting that shows cracks or flow restriction