Autopilot Eclipse F90 Master Environmental Controller

The Autopilot Eclipse F90 Master Environmental Controller centralizes the control of temperature, humidity, and CO2 in your grow room in a single unit. Three digital displays continuously show the three parameters, and LED indicators show which mode is active or if an error has occurred, so you can read the environmental status at a glance.

Benefits

• Four dedicated outlets: cooling, heating, humidification/dehumidification, and CO2 in ppm.
• Simultaneous reading of temperature, relative humidity, and CO2 on separate screens.
• Integrated data logger that saves the minimum and maximum values for all three parameters.
• Smart remote probe that can be placed up to 15 feet from the controller, to measure where the plants actually are.
• Reinforced covers on the four outlets to prevent the entry of ambient moisture.

How to use

Mount the controller on the wall and place the probe at canopy height, in the center of the space. Connect the cooling unit, heater, humidifier or dehumidifier, and CO2 system to their respective outlets, and manually test each output during installation. Operates at 120 V with a maximum consumption of 14.5 A.

Available at Pachamama, with shipping throughout Costa Rica.

Technical Specifications

• Controls: temperature (heating/cooling), humidity (humidification/dehumidification), and CO2
• 9 programmable outlets for complete environmental automation of the grow room
• Integrated CO2, temperature, and humidity sensors — all-in-one measurement
• Differentiated day and night settings allow independent climate targets for each light cycle
• Multiple high-temperature and high-CO2 safety protocols to protect plants and equipment

Instructions for use

• Mount the controller at canopy height and in the center of the grow space for greater accuracy
• Program independent day and night set points for temperature, humidity, and CO2
• Connect HVAC, dehumidifiers, humidifiers, CO2, and extractors to the identified outlets
• Manually test all outlets during initial installation to confirm the operation of each piece of equipment
• Clean the integrated sensor probe every month and recalibrate the CO2 sensor according to the manufacturer's schedule