Autopilot PX2 Advanced Lighting Controller

The Autopilot PX2 Advanced Lighting Controller is an indoor grow lighting controller that manages the photoperiod and intensity of up to 512 luminaires from a single point, distributed across two independent zones. It replaces traditional lighting contactors and eliminates inrush current, simplifying the electrical installation of medium and large rooms.

Benefits

• Two independent zones: 512 digital HID luminaires (256 per zone) or 100 analog LED luminaires (50 per zone).
• Compatible with controllable Phantom and Core HID luminaires and PHOTOBIO LEDs; each zone can operate in analog or digital mode.
• Sunrise and sunset simulation for a gradual increase and decrease in intensity.
• Two temperature probes, one per zone, enabling automatic temperature dimming and heat protection shutdown.
• Shielded cables against electromagnetic interference for a reliable signal.

How to use

Connect each zone to its luminaires with the included data cables and place the corresponding temperature probe inside the area it controls. Define the photoperiod, intensity level, and sunrise and sunset ramps for each zone, and adjust the temperature shutdown threshold. It is powered by 100 to 240 V, 50/60 Hz.

Available at Pachamama, with shipping throughout Costa Rica.

Technical specifications

• Controls up to 1000W HID lights or 0–10V dimmable LED/CMH lights
• 12 programmable time slots for advanced light scheduling in a 24-hour cycle
• Sunrise/sunset simulation with dimming for gradual light transition
• High-temperature safety shutdown that disconnects lighting during extreme heat events
• Compatible with most dimmable ballasts and 0–10V capable LED drivers

How to use

• Program desired light intensity levels and schedule for each of the 12 daily time slots
• Activate sunrise/sunset mode to gradually increase and decrease light intensity at the beginning and end of each cycle
• Set the appropriate high-temperature cutoff threshold for the grow room environment
• Connect only dimmable ballasts or 0–10V compatible LED drivers to this controller
• Check electrical connections and inspect for wear or heat damage in each grow cycle