Hydrofarm Power Cord 240V 8ft (16/3)

The Hydrofarm Power Cord 240 V 8 ft (16/3) is the replacement power cord to connect your grow ballast to a 240 V outlet. It is 8 ft long and uses AWG 16/3 gauge, meaning three conductors with a ground line included, so it supports the power consumption of an HID lighting system without overheating. It is the direct replacement when the original cable was damaged, lost, or too short for your grow room's new layout.

Benefits

• 8 ft long: reaches the outlet without resorting to makeshift extensions.
• AWG 16/3 gauge with ground conductor, designed for ballasts.
• Direct replacement, cheaper than replacing the entire ballast.
• Avoids typical voltage drops from thin household cables.

How to use

With the ballast disconnected from the power, connect the female end to the equipment's power input and the male end to the 240 V outlet. First, confirm that the circuit and outlet are actually 240 V: this cable is not for 120 V. If you have doubts about your room's wiring, consult an electrician.

Available in our store, with shipping to all of Costa Rica from Pachamama Indoor Farming Culture.

Technical Data Sheet

• Length: 8 ft | Voltage: 240V | Gauge: 16/3 | Brand: Hydrofarm | Type: Power cord for HPS/MH
• Reinforced 16/3 AWG construction certified for 240V ballast connections
• The 8 ft length provides flexibility for locating ballasts away from the outlet
• Replacement power cord for 240V grow light ballasts
• Verify that the plug type and connector match the ballast before purchasing

How to Use

• Ensure the ballast is off before connecting or disconnecting the power cord
• Locate the cord away from heat sources, standing water, and walkways
• Do not bend, pinch, or tightly coil the cord while in use
• Inspect the cord before each grow cycle for damage or wear
• Store it loosely coiled in a dry place when not in use